How to Put a Wire on the Back of a Picture Frame Arts to Frames

Hanging framed art seems straightforward enough, right?

A photograph or art slice, a custom or ready fabricated frame, a boom & hammer. Err ... well, scratch the smash and hammer.

The Problem - Frame Hangs Face up Forward

Frames are traditionally prepared with a hang wire on the rear. It is typically mounted to the side rails of frames about one/three downward from the top of the frame. Likewise, this wire is traditionally longer than information technology need exist. There is slack in information technology by some inconsistent corporeality. When hung from a hanging arrangement cable, or rod, this standard frame preparation will frequently cause the top of the frame to hang away from the wall, what we call face up forward.

The Solution - Relocate and Tighten Hang Wire

To manage face up forward, but movement the hang wire attachment points upwards on the frame and while doing so, remove the extra hang wire length. Non certain where to locate the attachments? That depends on the size and weight of the frame. The rule of pollex is that y'all want to mount these as high equally possible on the frame side rails, only just low enough so that the organisation claw will still be subconscious behind the height of the frame. When you lot support the frame from your finger at the center of the hang wire, the wire should be no closer than i-1/4" - ane-1/2" from the frame top edge.

Pick 1 - Bumpers

If you adopt, y'all may also leave the original hang wire in identify and only add a second i for employ with hanging systems. This is something progressive custom framers do as a matter of grade and a valuable service enhancement for their clients. Once the frame wire has been relocated and tightened, at that place is one more footstep that will farther enhance the professional presentation. Add a pair of Bumpers to the rear lower corners of the frame. These act to create a minor space betwixt the wall and rear surface of the frame and lessens the face forward dynamic. It also adds a pleasant floating frame effect.

Pick 2 - Frame Stabilizer

The next bespeak to consider is whether your fine art slice will be hanging from a single cable or rod or two cables/rods. When hanging from ane cable or rod, add a Frame Stabilizer behind the frame. This is a device that attaches to the hanging system cable/rod at the bottom track of the frame. The objective is the same every bit the bumper, to create a bit of space behind the frame at the lower edge of the frame. However, this action in only appropriate when the art piece is hanging from 1 cable/rod centered backside the fine art.

Selection iii - Counter Weight Stabilizer

When hanging from ii cables/rods, replace the hang wire on the rear of the frame and install a Counter Weight Stabilizer . This clever device will use the weight of the frame to pull the height edge of the frame towards the wall. It includes the bumpers described before.

Note - Bumpers and Frame Stabilizers offer very similar results

Bumpers are less costly but are single use and attach to the rear of the art/frame with adhesives. Frame Stabilizers will concluding for decades and are infinitely reusable and do not have an impact on the art piece itself. As you lot can run into, regardless of an fine art piece being framed professionally or otherwise, there is yet potential for the acme of the frame to lean outward and away from the wall, ameliorate known as confront forrad. Past knowing these simple merely valuable tips and solutions for managing face forrard, the framed art will hang close to the wall, and pleasing to the heart.

Are you lot experiencing face forward when hanging fine art? Tell u.s. how these art brandish installation tips will help you.

If you accept questions or would like to acquire more about how our products can exist beneficial in your project, please contact our Customer Back up at info@ashanging.com, or give u.s. a call at 866 935-6949 (toll free).

When you hang with AS Hanging Systems, you Hang with the Best®

---

Hanging fine art is the differentiator and the ultimate personal touch on to i's home. Naught speaks more about the occupants, their tastes and preferences, their personality, or speaks to what they value, more the fine art they cull to place on the walls of their dwelling. Yet, tastes modify over fourth dimension. Values change. Budgets change. The one constant is "alter". The result – changes to displayed art.

Currently Viewing: How To Manage Face Forrard, cablevision based

This document is part of a series that were created to help optimize framed fine art, and other wall objects, for display via a hanging organization.

- Problem
Frame Tilts Left to Right
- Solution

Ready (Straighten) Frame Tilt

- Problem
Frame Tilts Forward (Cable Based)
- Solution

Manage Face Forward

- Problem
Unstable Frame
- Solution

Optimize Using two Cables

- Trouble
Frame Teeter-Totters
- Solution

Eliminate Teeter-Totter Frames

hernandezwhathim.blogspot.com

Source: https://www.ashanging.com/en_ca/blog/post/how-to-manage-face-forward-framed-art-cable-based